Process Abrafile
Today I get a piece of white colour acrylic to make it into a shape of a mouse. I went to drill finish all the holes, the holes for the follower, handle, end. Below is the picture of the bench drilling machine which is use to drill. I use a 6.0 diameter drill bit to drill a tight fit hole.Drilling Machine
I saw the dowel using the coping saw. The dowel I use 10cm to make the follower. Below is a picture of the coping saw.
Coping Saw
We clamp the dowel to the table using engineer's vice.Engineer's Vice
I use abrafile to saw the middle of the dowel. I had to place my finger in the middle so that I will not saw at the side, which will cause the dowel to broke.
After sawing the middle of the dowel, I place the cheese in the middle of the hole which I saw. It will look like this.
Dowel with a cheese
Below is the cat which I saw last week using the scroll saw. I just added it in my design.
Jia Min ^-^
10:29 PM